VISIONPRO
®
8000 WITH WI-FI
®
43 33-00096—01
NOTE: To reduce costs, use the “Preset Energy-Saving
Schedules” on page 42.
3. Select the days to schedule, touch Next.
Fig. 40.
4. Touch or to set your Wake time for selected day(s).
5. Touch or to set Heat and Cool temperatures for the
Wake period.
6. Touch other time periods (Leave, Return, Sleep) to set
time and temperatures for each.
7. Touch Done to save and exit (Touch Cancel to exit with-
out saving changes).
Fig. 41.
NOTE: Touch Cancel Period to eliminate any unwanted
time period.
Touch Fan Setting to customize fan settings for
any time period.
Overriding Schedules: Residential
Use
1. Touch or to adjust the temperature (right side of
screen) and the Hold Until time (left side). The schedule
will resume when the Hold Until time expires.
Fig. 42.
2. Select Permanent Hold to keep the same temperature
until you change it or resume the program schedule.
Touch Cancel Hold at any time to resume the program
schedule.
Overriding Schedules: Commercial
Use
Touch or to adjust the temperature. It will be maintained
until the hold time you set.
• To change the hold time, touch the Hold Until arrow buttons.
This time can be adjusted up to the maximum time set by
the installer.
Fig. 43.
• Touch Override to use a pre-set occupied temperature if a
person uses the room during an unoccupied period. The
new temperature will be maintained for 1 hour and can be
adjusted up to the maximum time set by the installer.
MCR34151
Select the days
to schedule
MCR34152
Set Wake
time & temperature
MCR34103
Temporary Hold
Permanent Hold
MCR34169
To Next Page
Loading...
