8 - 31
UPC-E0 Number System
The numeric system digit of a UPC-A symbol is normally transmitted at the beginning of scanned data. When using UPC-
E Expand, the unit can be programmed so it will not transmit it. Default = On.
UPC-E0 Number System and Check Digit
UPC-E0 Check Digit
Check Digit specifies whether the check digit should be transmitted at the end of the scanned data or not. Default =
Off.
UPC-E0 Leading Zero
This feature allows the transmission of a leading zero (0) at the beginning of scanned data. To prevent transmission, scan
Off. Default = Off.
Check
Digit
Number
UPC-E0 sample showing the number system and check digit:
To Next Page
Loading...
