Honeywell VOYAGER 1202G BF - Page 192

11 - 20
ISBT 128 User-Defined Concatenation
Sequences On/Off
*Off ISBUCE0 8-21
Allow User-Defined Sequence ISBUCE1 8-21
Require User-Defined Sequence ISBUCE2 8-21
Content Verification *Off ISBXM00 8-21
On ISBXM01 8-21
Transmit Identifiers Off ISBXM10 8-22
*On ISBXM11 8-22
Flag Conversion *Off ISBXM20 8-22
On ISBXM21 8-22
GS1-128 Default All GS1-128 Settings GS1DFT 8-23
*On GS1ENA1 8-23
Off GS1ENA0 8-23
GS1-128 Application Identifier Parsing *Off GS1EMU0 8-23
Transmit Without Identifiers GS1EMU1 8-23
Transmit With Identifiers GS1EMU2 8-23
GS1-128 Redundancy Range (0 - 10) *0 GS1VOT## 8-23
GS1-128 Message Length Minimum (1 - 80) *3 GS1MIN 8-24
Maximum (0 - 80) *80 GS1MAX 8-24
Telepen Default All Telepen
Settings
TELDFT 8-24
*Off TELENA0 8-24
On TELENA1 8-24
Telepen Output *AIM Telepen Output TELOLD0 8-24
Original Telepen Output TELOLD1 8-24
Telepen Redundancy Range (0 - 10) *0 TELVOT## 8-25
Telepen Message Length Minimum (1 - 80) *3 TELMIN## 8-25
Maximum (1 - 80) *80 TELMAX## 8-25
UPC-A Default All
UPC-A Settings
UPADFT 8-25
Off UPBENA0 8-25
*On UPBENA1 8-25
UPC-A Number System Off UPANSX0 8-26
*On UPANSX1 8-26
UPC-A Check Digit Off UPACKX0 8-26
*On UPACKX1 8-26
UPC-A 2 Digit Addenda *Off UPAAD20 8-26
On UPAAD21 8-26
UPC-A 5 Digit Addenda *Off UPAAD50 8-27
On UPAAD51 8-26
UPC-A Addenda Required *Not Required UPAARQ0 8-27
Required UPAARQ1 8-27
Addenda Timeout Range (0 - 65535) *100 DLYADD##### 8-27
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric entry
Page