Honeywell Voyager 1450g2DHR Series - Honeywell Bioptic Aux Port Configuration; Datalogic Magellan © Bioptic Aux Port Configuration; NCR Bioptic Aux Port Configuration

2 - 6
Honeywell Bioptic Aux Port Configuration
Note: This interface is not supported by the Voyager 1450g2DHR.
Scan the following Plug and Play code to program the scanner for a Honeywell bioptic scanner auxiliary port configuration. This
bar code sets the baud rate to 38400 bps and the data format to 8 data bits, no parity, 1 stop bit.
Datalogic™ Magellan
©
Bioptic Aux Port Configuration
Note: This interface is not supported by the Voyager 1450g2DHR.
Scan the following Plug and Play code to program the scanner for a Datalogic Magellan bioptic scanner auxiliary port configura-
tion. This bar code sets the baud rate to 9600 bps and the data format to 8 data bits, no parity, 1 stop bit.
NCR Bioptic Aux Port Configuration
Note: This interface is not supported by the Voyager 1450g2DHR.
Scan the following Plug and Play code to program the scanner for an NCR bioptic scanner auxiliary port configuration. The fol-
lowing prefixes are programmed for each symbology:
Symbology Prefix Symbology Prefix
UPC-A A Interleaved 2 of 5 b
UPC-E E0 Code 128 f
GS1 DataBar
Omnidirecitonal
r
EAN-8 FF GS1 DataBar
Expanded
r
EAN-13 F Codabar N
Code 39 a Code 32
Pharmaceutical
(PARAF)
a
Honeywell Bioptic Settings
Datalogic Magellan Bioptic Settings
NCR Bioptic Settings