Honeywell Voyager 1450g2DHR Series - Wincor Nixdorf Terminal Default Settings; Wincor Nixdorf Beetle Terminal Default Settings

2 - 7
Wincor Nixdorf Terminal Default Settings
Note: This interface is not supported by the Voyager 1450g2DHR.
Scan the following Plug and Play code to program the scanner for a Wincor Nixdorf terminal. This bar code sets the baud rate
to 9600 bps and the data format to 8 data bits, no parity, 1 stop bit.
Wincor Nixdorf Beetle™ Terminal Default Settings
Note: This interface is not supported by the Voyager 1450g2DHR.
Scan the following Plug and Play code to program the scanner for a Wincor Nixdorf Beetle terminal. This bar code sets the
baud rate to 115200 bps and the data format to 8 data bits, no parity, 1 stop bit. The following prefixes are programmed for each
symbology:
Symbology Prefix Symbology Prefix
Aztec Code V Interleaved 2 of 5 I
Codabar N MaxiCode T
Code 93 L MicroPDF417 S
Code 128 K PDF417 Q
Data Matrix R QR Code U
EAN-8 B Straight 2 of 5 IATA H
EAN-13 A UPC-A A0
GS1 DataBar E UPC-E C
GS1-128 P All other bar codes M
Wincor Nixdorf Terminal Settings
Wincor Nixdorf Beetle Settings