Reading Techniques
The view finder projects an aiming
dot that should be centered over the
bar code, but it can be positioned in
any direction for a good read.
Hold the scanner over the bar code,
press the button, and center the
aiming dot on the bar code.
The aiming dot is smaller when the
scanner is closer to the code and
larger when it is farther from the
code. Hold the scanner close to
smaller bar codes, and farther away
from large bar codes to get a proper
read.
If the bar code is highly reflective (e.g., laminated), you may need
to tilt the scanner at an angle so the bar code can be scanned.
Standard Product Defaults
The following bar code resets all standard product default set-
tings.
Note: PDF and 2D bar codes can only be read by Voyager model
1470g2D and cannot be read by model 1470g1D.
To Next Page
Loading...
