Honeywell Xenon 1500 - Page 138

9 - 14
Data Formatter Selections
Data Format Editor *Default Data
Format (None)
DFMDF3 5-1
Enter Data Format DFMBK3## 5-2
Clear One Data
Format
DFMCL3 5-3
Clear All Data
Formats
DFMCA3 5-3
Data Formatter Data Formatter Off DFM_EN0 5-7
*Data Formatter On,
Not Required
DFM_EN1 5-8
Data Format
Required
DFM_EN2 5-8
Primary/Alternate
Data Formats
Primary Data
Format
ALTFNM0 5-8
Data Format 1 ALTFNM1 5-8
Data Format 2 ALTFNM2 5-8
Data Format 3 ALTFNM3 5-8
Symbologies
All Symbologies All Symbologies Off ALLENA0 6-2
All Symbologies On ALLENA1 6-2
Codabar Default All Codabar
Settings
CBRDFT 6-3
Off CBRENA0 6-3
*On CBRENA1 6-3
Codabar Start/Stop
Char.
*Don’t Transmit CBRSSX0 6-3
Transmit CBRSSX1 6-3
Codabar Check
Char.
*No Check Char. CBRCK20 6-4
Validate, But Don’t
Tra nsmit
CBRCK21 6-4
Validate, and
Tra nsmit
CBRCK22 6-4
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page