Honeywell Xenon XP 1950g - Page 286

268 Xenon XP User Guide
QR Code Append *One Scan QRCAPP1 198
Swipe QRCAPP2 198
Point & Shoot QRCAPP3 198
Off QRCAPP0 198
QR Code Page QR Code Page (*3) QRCDCP## 199
DotCode Default All DotCode Settings DOTDFT 200
On DOTENA1 200
*Off DOTENA0 200
Poor Quality DotCodes Poor Quality DotCodes On DOTEXS1 200
*Poor Quality DotCodes Off DOTEXS0 200
DotCode Msg. Length Minimum (1- 2400) *1 DOTMIN#### 200
Maximum (1- 2400) *2400 DOTMAX#### 200
Digimarc Barcode Decoder Attempts (0-10) *3 DIGSTR## 201
Off DIGENA0 201
On DIGENA1 201
Uses ID Decoder then Both
Decoders
DIGENA2 201
*Uses Digimarc Decoder then
Both Decoders
DIGENA3 201
Uses ID Decoder then Alternates
Decoders
DIGENA4 201
Uses Digimarc Decoder then
Alternates Decoders
DIGENA5 201
Data Matrix Default All Data Matrix Settings IDMDFT 201
*On IDMENA1 201
Off IDMENA0 201
Direct Part Marking (DPM)
Decoding
Dotpeen DPM Decoding DPMENA1 202
*Disable DPM Decoding DPMENA0 202
Reflective (Etched) DPM
Decoding
DPMENA2 202
Data Matrix Msg. Length Minimum (1-3116) *1 IDMMIN#### 203
Maximum (1-3116) *3116 IDMMAX#### 203
Data Matrix Code Page Data Matrix Code Page (*51) IDMDCP## 203
MaxiCode Default All MaxiCode Settings MAXDFT 204
On MAXENA1 204
*Off MAXENA0 204
MaxiCode Msg. Length Minimum (1-150) *1 MAXMIN### 204
Maximum (1-150) *150 MAXMAX### 204
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page