Unlinking the Scanner If the base has a scanner linked to it, that scanner must be unlinked before a new scanner
can be linked. Once the previous scanner is unlinked, it will no longer communicate with the base. Scan the Unlink
Scanner barcode to unlink a scanner.
Unlink Scanner
Trigger
The following barcodes will allow you to use the scanner in Manual Trigger – Normal Mode (need to press the trigger
to read) or Presentation mode (the scanner is activated when it “sees” a barcode). Note: Presentation Mode
continuously draws power, so use of
the external power supply is recommended for this mode.
Manual Trigger – Normal (Default)
Presentation Mode
Streaming PresentationTM
When in Streaming Presentation mode, the scanner leaves the scan illumination on all the time and continuously
searches for barcodes.
Streaming Presentation Mode
Suffix
If you want a carriage return after the barcode, scan the Add CR Suffix barcode. To add a tab after the barcode, scan
the Add Tab Suffix barcode. Otherwise, scan the Remove Suffix barcode to remove the suffixes.
Add CR Suffix
Add Tab Suffix
Remove Suffix
Add Code ID Prefix to all Symbologies Scan the following barcode if you wish to add a Code ID prefix to all
symbologies at once.
Add Code ID Prefix To All Symbologies (Temporary)
Note: For a complete list of Code IDs, see the User Guide for your product.
To Next Page
Loading...
