Hoonved APS 43 User Manual

21
SERIE APS/FW
3.3.g Turn-off (Fig. 1)
At the end of the day to take off the line button (1) Fig. 1;
automatically the tank water will be discharged. Disconnect
main switch and close the hydric alimentation tap.
ATTENTION
Switch off the main circuit-breaker prior to the machine
and turn off the water delivery cocks if the dishwasher is
faulty or operates badly.
Only allow the manufacturer’s authorized after-sales
service center to make repairs.
3.4 LOW DETERGENT AND RINSING
AGENT INDICATORS
Before beginning the cycle, make sure that warning lights
(5) and (6) Fig. 1 are off. When one of the two warning
lights (5) or (6) Fig. 1 is flashing in normal mode indicates
that the respective product is insufficient.
Light 5 - Detergent
Light 6 - Rinsing agent
4. CLEANING (Fig. 10)
4.1 General information
Strict compliance with the maintenance instructions in this
section will keep your machine in a good working condition
and will notably reduce the need for repairs.
ATTENTION
If any machine component becomes faulty, FIRST CHECK
that all the instructions given in the previous paragraphs
have been complied with during use.
Repairs must be carried out immediately, as soon as the
fault occurs. This will prevent the trouble from becoming
worse and damaging other parts.
4.2 Daily cleaning (Fig. 10)
ATTENTION
Daily operations to carry out when work has ended, with
the machine off, the main circuit-breaker disconnected,
the water cocks off and the washing tub empty.
1. Thoroughly clean the inside parts of the machine.
2. Pull out the filter (27) as indicated in Fig. 10.
3. Remove the pump safety filter (28).
4. Wash the filters under running water and fit them
correctly back in their housings.
ATTENTION
Frequently check and clean the spraying units, removing
them from their housings and eliminating any dirt and
fouling. The frequency with which this operation must be
carried out depends on the quantity of dirt or on the
unsatisfactory washing results. Never use corrosive
products like sodium hypochlorite (bleach) or hydrochloric
acid, wire wool or steel brushes to clean either the inside
or outside parts of the machine.
5. PREVENTIVE MAINTENANCE (Fig. 11)
ATTENTION
ENGLISH
The preventive maintenance operations must be carried
out with the machine off, the main circuit-breaker
disconnected, the water delivery cocks off and the washing
tub empty.
5.1 Checking and cleaning the rods and nozzles (Fig.
11)
Periodically check that the washing rod (29), the lower
rinsing rod (30) and the relative nozzles are not clogged.
Cleaning the unit:
1. Unscrew the wing nut (31) and turn it through 180°,
then unscrew the central plug (32), removing the rods
(29) and (30).
2. Wash the washing and rinsing rods. If the nozzles (33)
are clogged, demount them and clean them using a
steel rod, preventing the nozzles from being damaged.
Now fit them back exactly in their original positions.
3. Remount all parts by complying with the above
instructions in reverse.
6. TEMPORARY INACTIVITY (Fig. 12)
If the machine is to remain inactive for a certain period of
time, disconnect the electrical power source and turn off
the water delivery cocks. Leave the tub door open.
• Drain off the water from the boiler by placing a vessel
under it and unscrewing the relative drain screw (34).
Wait until the boiler has emptied, then fit the screw back
in place (34).
7 DEMOLITION and DISPOSAL
When the machine is to be scrapped, drain the water
from the tank and from the boiler, as indicated in the
points above, and disconnect the machine from the water
and electricity supply networks, then dispose of the
components according to current regulations, respecting
national and local ecological and environmental
legislation, and taking care to separate the parts as
follows:
- metallic parts: body work, surfaces, panels, filters;
- electrical parts: motors, remote switches, micro-
switches, cabling;
- plastic parts: connectors, baskets;
- rubber parts: tubes, couplings
The producer declines all responsibility for any
printing errors contained in this booklet.
The instructions, drawings, tables and everything
else in this manual are of a confidential technical
nature. For this reason, none of the information may
be either completely or partially duplicated or disclosed
to third parties without prior written authorization
from HOONVED which is the sole proprietor and
which reserves the right to make any modifications as
may be considered necessary without advance
warning.

Hoonved APS 43 Specifications

General

Brand	Hoonved
Model	APS 43
Category	Dishwasher
Language	English