30
ENGLISH
Part 2: For the operator
3) During rinsing, the boiler temperature is indicated
and the display LEDs light up in sequence;
4) For the last 20 sec. of the cycle, when the drainage
pump is in operation, the tank temperature is display-
ed once again.
By pressing the START “S3” button again, a new wa-
shing cycle will begin.
ATTENTION
We recommend that you replenish detergent used up
by washing fats or dispersed during rinsing every 4-5
complete cycles.
This machine guarantees rinsing at temperatures ideal
for hygienic purposes;
indeed, if this is not sufcient, the washing cycle is
automatically extended so as to provide the necessary
conditions for optimum rinsing at 85°C.
The waiting time required to attain optimum tempera-
ture can extend to a maximum of 8 minutes.
2.1.e.2 Interrupting the cycle
1) It is possible to pause the washing cycle in case of
EMERGENCY, by opening the door;
the message “F1” will appear on the display;
normal operations will resume on closing the door.
2 ) The cycle will also be interrupted by SWITCHING
OFF the machine using the “Q1” button.
3) On switching the machine back on, the LED indica-
ting the last cycle selected will light up, and the alarm
message “A1” will appear on the display;
this will disappear when a new cycle is begun.
At the end of the washing cycle, take out the basket
and shake it gently so as to remove the last drops left
on the washed items.
Allow items to dry and remove them from the basket
with clean hands.
Store all items on hygienic and completely stable sur-
faces.
2.1.f Self-washing and Draining
When you have nished washing, SWITCH OFF the ma-
chine by pressing the “Q1” button.
Having drained the machine and released the overow,
close the tank-access door and keep press the START
“S3” buttonpressed for approx . 3 seconds an then relea-
se it.
The self-washing and draining cycle will begin, and the
drainage pump will be activated (where tted); the messa-
ge “C1” will appear on the display for 2 min., 20 sec.
2.1.g Manual Draining
It is possible to drain the water from the tank at any time
during the day, according to the waste accumulated.
To carry out this operation, proceed as follows:
- SWITCH OFF the machine and release the overow
allowing all the water to drain from the tank;
- Remove the tank lters(22) and clean;
Manual draining for machines with drainage pump
For machines tted with a drainage pump it is possi-
ble to empty the tank by carrying out the manual draining
cycle, during which only the drainage pump remains acti-
ve.
ATTENTION
This cycle can only be carried out by leaving the machine
SWITCHED ON and the tank full of water, indipendently
from the hood, which can be open or closed.
Having released the overow, press the “S9” or
CYCLE button for 5 sec.; the drainage cycle will begin.
The message “C2” will appear on the display for 4 min.,
20 sec.
ATTENTION
By pressing the “S9” or CYCLE button you can inter-
rupt the drainage cycle before the preset time is up.
At the end of the cycle, restore the lters (22) (24) and
the overow (23) to their respective positions.
LC1 LC2 LC3 LC4
To Next Page
Loading...
Need help?
General
