Hoonved C 81 E - Troubleshooting

34
TROUBLESHOOTING
PROBLEMS
The machine fails to turn on.
The machine does not ll with
water.
Insufcient washing.
Insufcient rinse.
CAUSES
Main switch disconnected.
Water cock shut.
Dirty ll pipe lter.
Rinsing nozzle clogged.
Overow pipe not well connected.
ALARM A4:
Lack of water in tank
MESSAGE F1:
Door Open
Wrong pump rotation direction.
Clogged washing nozzles.
Dirty washing lter.
Clogged washing blade.
No detergent.
ALARM H3:
Insufcient wash temperature
ALARM A3:
Probe disconnected or interrupted
Insufcient washing conditions
.
Clogged rinsing nozzles.
Clogged boiler by limestone.
Low main pressure
(less than 2 bar. - 200 Kpa).
Insufcient temperature.
Bad location of the nozzles or damaged
nozzles.
ALARM H1:
Insufcient rinse temperature
ALARM A3:
Probe disconnected or interrupted
ALARM A5:
Boiler heating failure
SOLUTIONS
Turn on the switch.
Turn on the clock.
Detach the ll pipe (13 Fig. 6) and clean the lter.
Unscrew and clean the nozzles (28 Fig. 9) under
running water.
Check the right con. of the overow pipe (23 Fig. 9)
Check presence of water in system;
Switch machine off and back on
Check that the door is perfectly closed and/or the
machine is properly levelled
Call the technician to reverse 2 of the 3 wires on
the main switch.
Clean the washing blade (25 Fig. 9).
Clean the lters (22 e 24 Fig. 9).
Remove and clean the balde (25 Fig. 9)
Add detergent and ll the dispenser.
Wait for tank to reach correct temperature
Contact Assistance Centre
Check the correct washing phase.
Unscrew and clean the nozzles (28 Fig. 9) under
running water.
Call after-sales service.
Wait pressure recovery or purchase a new pressu-
re pump.
Call after-sales service.
Check the right location of the nozzles and replace
damaged ones.
Wait for boiler to reach correct temperature
Contact Assistance Centre.
Contact Assistance Centre.
ENGLISH
Part 2: For the operator