TYPES OF WAX
WATER-BASE WAX
Th
is wax contains no petroleum
solvent. It can be used on all hard surface floors including
sealed
wood or cork. There are two types:
POLISHING WAX
- such as Hoover Floor Wax.
SELF- POLISHING WAX.
SOLVENT-BASE WAX
This wax can be identified by
its naphtha (dry-cleaning) odor. The container is labeled
“Inflammable” or “Combustible”. It is used for cleaning
all wood and cork floors. It is the only type of wax that
should be used on wood or cork floors that are unsealed
or worn.
Do not use on asphalt or rubber tile.
There are two types:
PASTE WAX.
LIQUID POLISHING WAX
- this type of wax con-
tains more solvent than paste wax. It is used to clean
as well as to wax floors.
HOW TO WAX FLOORS
Before starting to wax be sure floor is free of surface dirt.
Use vacuum cleaner for dust and dirt and a damp sponge
for sticky particles.
Wax should be used sparingly. A heavy coat will dry on
the surface but remain sticky and gummy underneath.
This gives a slippery finish and does not polish evenly.
One thin coat of wax is sufficient for most floors, but two
thin coats-polishing after each application-usually give
a better finish.
TO APPLY WATER-BASE WAX Wax can be applied to the
floor quickly and easily with Hoover Dispensers, Models
7010 or 7011. (See page 9.) Directions for using dispensers
5
To Next Page
