10
MAINTENANCE
Cleaning the post-motor filter
Cleaning the filter and separator
Press the filter cover
release buttons located
on both sides of the filter
cover and pull
to remove the filter
from the machine.
Turn the handheld
over and press the dirt
container release button.
Pull the dirt container
forward and up away
from the handheld
to remove.
Twist the mesh filter
anti-clockwise to
unlock, lift to remove
from the separator.
Twist the separator
anti-clockwise to
unlock, lift to remove
from the handheld.
Leave for 24hrs
or until fully dry
before replacing.
Pull to separate the filter from the filter
cover/holder. Tap the filter and filter
cover/holder over a bin to remove
any dirt/debris. Wash the filter under
running water (40 degrees max).
CAUTION: Always remove the battery from the vacuum cleaner before performing maintenance
or troubleshooting checks. For continuous best performance the filter requires cleaning every 3
months and should be replaced every 12 months depending upon use. Do not use your vacuum
cleaner without the filters in place.
CAUTION: Always empty the dirt container before cleaning the separator and filter and remove
the battery, reach wand/accessories from the handheld.
24hr
To Next Page
Loading...
