12
MAINTENANCE
CAUTION: Incorrect fitting of the separator and filter will reduce suction.
Removing blockages from the Powered Head
The brushbar should be removed from the Powered Head before
attempting to remove any blockages. Using scissors remove any
threads or hair from around the brushbar and clear any dirt or
debris from Powered Head.
IMPORTANT: If the brushbar has been obstructed, the Motor Protection Sensor may have been
activated and the brushbar will seize. Remove the Powered Head from the machine and clear
any obstruction. Refit the Powered Head, switch on the vacuum cleaner by pressing the trigger
and press the brushbar on/off button.
Slide to release the
brushbar. The cover
can not be removed.
Clear any threads
or hair from both
ends of the brushbar
and any dirt/debris
inside the housing of
the Powered Head.
When re-fitting
the brushbar fit
the right side
into the housing
first. Then line
up and slot into
place the left side.
Removing blockages from reach wand
To test for a blockage in the reach wand,
drop a small ball of paper into the wand.
The paper will drop through if the wand
is clear. Use a broom handle or similar
blunt object to remove any blockage.
Lift to remove the
left side of the
brushbar first.
Removing and replacing the brushbar
To Next Page
Loading...
