Hoover Dv16 011 - Cleaner Maintenance; User Checklist

3
CLEANER MAINTENANCE
Replacing the disposable bag
1. Lay the cleaner on a at surface, pull back the door release button and remove the
bag door. [12]
2. Remove the disposable bag, close the ap to lock the contents and dispose. [13]
3. Take a new bag and t the collar with the location in the main body and rotate until xed. [14]
4. Locate tabs on door as shown and close door.
Attention: This product is tted with a mechanism that prevents the door closing when
there is no bag tted.
NOTE: The bag may need changed frequently when picking up material such as powder
or ne dust or when cleaning new carpets.
Cleaning the washable pre-motor lter
1. Lay the cleaner on a at surface, pull back the door release button and remove the
bag door. [12]
2. Remove the old pre motor lter by pressing the nger tab to release. [15]
3. Gently tap the lter against the side of a bin to release excess dust. [16]
4. If deeper cleaning is required: Wash the lter thoroughly under hand warm water
until the water runs clean. [17]
5. Remove excess water by shaking and leave to dry for 24 hours. DO NOT USE HOT
WATER OR DETERGENTS. [18]
6. Ret bag door as above.
IMPORTANT - For optimum performance, shake off excess dust from the lters regularly.
We recommend that the lter is washed every 3 months.
NOTE: Do not use the cleaner without lters assembled.
ACCESSORIES
To obtain the best performance and efciency it is recommended that the correct nozzles
are used for the main cleaning operations. These nozzles are indicated in the diagrams
by the letters GP, HF or CA.
A nozzle type GP can be used to clean both carpet and hard oor.
A nozzle type HF is suitable for use only on hard oor.
A nozzle of type CA is suitable for use only on carpet.
The other nozzles are accessories for specialist cleaning tasks and are recommended
for occasional use only.
All accessories can be tted to the end of the handle or the end of the telescopic tube.
*Certain Models Only ** Certain models only, nozzles may vary according to model
Parquet Nozzle* – For parquet oors and other delicate floors.
Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep cleaning on textile
surfaces and other hard to clean areas. Particularly suitable for allergen removal.
IMPORTANT: Do not use the turbo and mini turbo nozzles on rugs with long fringes,
animal hides and carpet pile deeper than 15mm. Do not keep the nozzle stationary while
the brush is rotating.
GB
USER CHECKLIST
Should you have a problem with your product, complete the simple user checklist before
calling the Hoover customer service.
• Is there a working electricity supply to the product? Check with another electrical
product.
• Is the bag full? Inspect and replace.
• Is the hose blocked? Check by stretching to the full length.
• Is the product inlet blocked? Check by removing the bag and checking the bag
inlet.
• Is the filter blocked? Check by removing and clean.
IMPORTANT INFORMATION
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local
Hoover dealer or direct from Hoover. When ordering parts always quote your model number.
Consumables
Microber bag (x4) H68 - 35601148
Pre-motor lter S101 - 35601149
Spare parts
Hard Floor Extra Nozzle G216EE - 35601609
Hard Floor Smart Nozzle G218SE - 35601618
Carpet & Floor Pro Nozzle G233PE - 35601672
Carpet Extra Nozzle G215EE - 35601608
Parquet Extra Nozzle G87PC - 35600655
Allergy Remover Nozzle J49 - 35601152
Grand Turbo Nozzle J48 - 35601151