4-6
4-4
Storage
Before storing cleaner:
Turn cleaner OFF and disconnect
from electrical outlet.
• Empty and rinse solution and recov-
ery tanks. Allow to air dry.
• Allow filter in recovery tank lid to
dry.
• Set the cleaner for “Dry Vacuuming”
(pedal to “DRY” and Wet Control
switch up).
• Make sure that nothing is pressing
on the nozzle squeegee.
• Do not store cleaner on a wood sur-
face unless cleaner is completely
dry.
11
Cleaning the brushes
Turn cleaner OFF and disconnect
from electrical outlet.
The brush assembly can be removed
for easy cleaning.
Continued
4-5
Remove nozzle as described in Fig.
4-1 through 4-3.
Using finger grips (E) on the brush
assembly (F), pull straight out.
The brush assembly can be washed
with a mild detergent and rinsed. Do
not use pine or solvent-based deter-
gents.
To replace nozzle, make sure latches
are out. Align middle section (D) of
nozzle with opening on cleaner.
While holding nozzle in place, slide
latches inward to lock in place.
4-7
Align tabs (G) on brush assembly
with slots (H) in cleaner.
Slide brush assembly into place.
Replace nozzle as described in Figs.
4-4 and 4-5.
D
H
G
F
E
To Next Page
Loading...
