1-3
1-6
1-4
1-5
With cord hook (B) to back of cleaner,
push upper handle down onto cleaner.
Insert screw with washer in front of
tank area. Tighten screw with a
Phillips screwdriver.
Replace clean solution tank by posi-
tioning bottom first. Press latch and
snap top portion into place.
Insert two screws into back of handle
as shown. Tighten with a Phillips
screwdriver.
4
B
C
1-7 1-8
F
E
D
G
H
G
To install brush assembly and nozzle,
place handle in upright position.
Align tabs (D) on brush assembly with
slots (E) in cleaner.
Slide brush assembly (F) into place.
While holding nozzle in place, slide
latches inward to lock in place.
Remove cardboard packing insert
from squeegee area on underside of
nozzle.
1-9 1-10
Push brush control switch (C) down to
connect switch rod. You will hear a
“click” when the switch rod is in
place.
Cord clip
To help keep the cord out of the way
while cleaning, position cord down
into cord clip (I), located on the
handle.
I
To install nozzle, make sure latches
(G) are out.
Align middle section (H) of nozzle
with opening on cleaner.
To Next Page
Loading...
