88
Fig. 23
Fig. 22
Fig. 17
Fig. 18
Fig. 21
Fig. 20
MAINTAINING YOUR ROBOT CLEANER
EMPTYING THE DUST CONTAINER
After vacuuming, remove the dust container.
1. Press the release button and pull it out. [Fig. 17]
2. Hold the dust container over a dust bin. [Fig. 18]
3. Use the cleaning brush when necessary to remove any excess dust from the internal surface of the
dust container or ter surface.
4. Ret the dust container to the Robot.
CLEANING THE FILTERS
The robot is tted with a pre-motor lter. To maintain optimum cleaning performance, regularly
clean the lter cover, the pre-motor lter and the sponge lter. They should be cleaned every 5 dust
container empties and should not be washed.
1. Turn the robot off and remove from the charging station.
2. Press the dust container release button and remove the dust container from the Robot. [Fig. 17]
3. Remove all lter components and clean them separately. The assembly is done in reverse
order. [Fig. 19,20]
Make sure, that the lter insert is correctly assembled. To ensure this, press the shorter side wall into
the tting rst, before pushing in the lter on the other sides by pressing down on the edges.
IMPORTANT: Regularly check and maintain the lters by following the lter maintenance instructions.
This will maintain your Robot’s performance.
CLEANING ANTI FALL SENSORS
To maintain the safe operation of your robot it is important to keep the Anti fall sensors clean.
There are 3 sensors are located on the underside of the robot. Turn the robot upside down and clean
them with a soft brush to remove any accumulation of dust, dirt or debris. [Fig. 21]
CLEANING THE AGITATOR
Regularly clean the agitator to maintain maximum cleaning performance.
1. Turn the Robot off.
2. Turn the Robot over. [Fig. 22]
3. Press the clips on the sole plate, remove the cap and then remove the agitator. Remove hair and
lint, etc. by hand or with a brush.
CLEANING THE EDGE SIDE BRUSHES
The edge cleaning brushes can be easily worn from heavy use so you should check them regularly to
monitor their condition.
1. Switch the Robot off and turn it over.
2. Unclip the two edge side brushes.
3. Use a pair of scissors to remove any trapped hair or debris.
CLEANING THE DRIVE WHEELS
1. Switch the Robot off and turn it over.
2. Remove any dirt or hair trapped in the wheels.
3. Clean the wheels with a dry cloth. [Fig. 23]
IMPORTANT NOTICE
Only use approved replacement parts for your Robot.
Using parts not validated by Hoover are dangerous and will invalidate your guarantee.
If the Robot will not to be used for several months, please remove the batteries and store in cool a dry
location.
IMPORTANT: Always make sure your device is switched off before changing.
Fig. 19
GB
To Next Page
Loading...
Need help?
General
