Hoover ONEPWR Blade Max - MAINTENANCE; Dirt Container Management

9
MAINTENANCE
9
Removing and refitting the dirt container
Emptying the dirt container
CAUTION: Always remove the battery before carrying out any maintenance or troubleshooting.
CAUTION: Don’t over fill the dirt container to avoid blocking the air flow through the machine.
For best cleaning results, empty the dirt container after every use. Filters should be tapped over a bin every
4-6 uses to remove dirt and debris and washed every 3 months. Filters should be replaced every 6-9 months
depending on the level of use.
1. Squeeze the latch on the dirt
container to release.
2. Tilt and lift to remove from the
handheld.
1. Squeeze the latch on the dirt
container to release.
2. Tilt and lift to remove from the
handheld.
Hold the dirt container over a bin and
press the dirt release button to allow
dirt and debris to fall out.
To close, push the dirt release door
until it clicks into place.
To refit, line up the dirt container
connection with the handheld handle.
Push the dirt container back onto the
handle until it clicks into place.
When correctly fitted all 3
connection points will be aligned
and will sit flush.
2
1
2
1