9
Plug power cord into
electrical outlet.
To lift the stain,
suction up the dirt and
cleaning solution by
applying downward
pressure on the front of
the cleaning tool and
pulling towards you.
Repeat as needed.
1
4
Press Red Button on
top of unit to turn ON.
2
Spray a generous
amount of cleaning
solution over the soiled
area by pressing the
trigger behind the tool
and scrub the stain in a
back and forth motion.
3
How to Clean Carpets with your PowerDash
™
Spot Cleaner
*follow these steps for best results
For best results, pretreat stains with a HOOVER® spot treatment (see HOOVER® Cleaning Solution Guide) to help loosen
and remove even the most stubborn stains.
Distribute a generous amount of pretreat spray on spot, stain, or high trac area.
Always follow specific directions found on solution label.
Wait 5-10 minutes before using machine.
CAUTION:
Do not clean over floor electrical
outlets. Water will drip from the tool after use and
may puddle. To avoid damage to wood and laminate
flooring and to avoid potential slip hazard, after use
(a) do not leave the product on wood and laminate
surfaces and move to a hard surface and (b) place
unit on an absorbent material (such as a towel) to
soak up drips.
IMPORTANT:
For full suction, it is important
that the Dirty Water Tank is properly secured before
cleaning.
NOTE: Empty Dirty Water Tank when the motor sound
becomes higher pitched and there is a loss in suction
(see “Automatic shut-o”). You will also see the float
rise and shut o suction at the same time.
Continue using dry strokes until little water is visible
passing through the nozzle.
For best results, HOOVER® recommends rinsing carpet
with water only. This removes residual carpet cleaning
solution. Fill Solution Tank with water and repeat. For
heavily soiled areas, repeat. Avoid saturating carpet.
To Next Page
Loading...
Need help?
General
