Ifaminorproblemoccurs,itusuallycanbesolvedquiteeasilywhenthecauseisfoundbyusingthe
checklistbelow.
Anyotherservicingshouldbedonebyanauthorizedservicerepresentative.
,& WARNING
To reduce risk of personal injury - unplug vacuum before servicing.
PROBLEM
Vacuum won't
run
System Check
Indicator has
turned red
or
Vacuum won't
pick up
or
Low suction
Cord Rewind
does not work
Dust escaping
from vacuum
Headlight not
working
Vacuum is
difficult to push
or won't move
forward
Air-Powered
Hand Tool
brushroll won't
turn
POSSIBLECAUSE POSSIBLESOLUTION
2. Blown fuse or tripped breaker. 2. Check fuse or breaker in home. Replace
fuse/reset breaker in home.
1.Rinsable Filter and/or Filter
made with HEPA media is dirty.
3. Broken or worn belt.
5. Carpet height setting is
incorrect.
1. Clean Rinsable Filter and or Filter made
with HEPA media - Pg. 11.
3. Replace belt - Pg.14.
5. Set Carpet Height Adjustment to appropriate
setting for carpet being cleaned - Pg.7.
1. Cord reel does not retract. 1. Call 1-800-944-9200 for the nearest
authorized service representative.
2. Dirt cup not installed correctly. 2. Review Dirt Cup removal & replacement -
Pg. 11.
4. Rinsable and/or Filter made
with HEPA media not installed
completely.
2. Loose electrical wires.
2. Brushroll is activated.
2. Blockage.
4. Review Filter Removal and Cleaning - Pg.
11.
2. Call 1-800-944-9200 for nearest authorized
Hoover _ dealer.
2. For very high pile carpet deeper than 1",
turn brushroll off.
2. Remove blockage.
Smoky/burning 1. Belt broken or stretched. 1. Replace brushroll belt - Pg. 14.
smell detected
15
To Next Page
Loading...
