EN
6
1. Lower the throttle and throttle trim to the lowest
settings.
2. Power on the transmitter.
3. Install the ight battery in the battery holder.
4. Connect the battery cable to the 3-in-1 control unit.
NOTICE: Do not allow the helicopter to move until
the blue LED on the 3-in-1 control unit is solid.
NOTICE: Always disconnect the Li-Po battery from
the 3-in-1 control unit of the aircraft when not
ying. Failure to do so may result in over discharge.
Installing the Flight Battery
Transmitter and Receiver Binding
Binding is the process of programming the receiver of the control unit to recognize the GUID (Globally
Unique Identi er) code of a single speci c transmitter. You need to ‘bind’ your chosen Spektrum
™
DSM2
®
/ DSMX
®
technology equipped aircraft transmitter to the receiver for proper operation.
Binding Procedure for Computer Radios
1. Disconnect the ight battery from the helicopter.
2. Power off the transmitter and move all switches to the 0 position.
3. Connect the ight battery to the helicopter. The 3-in-1 Control unit LED ashes after 5 seconds.
4. Push the bind switch/button while powering on the transmitter.
5. After 2–3 seconds, release the bind switch/button.
6. Move the rudder control stick to full right. Continue to hold the rudder control stick to full right until
the blue LED on the 3-in-1 control unit is solid.
7. Release the rudder control stick.
8. Disconnect the ight battery and power the transmitter off.
NOTICE: The throttle will not arm if the transmitter’s throttle control is not put at the lowest position
and the stunt mode switch is not in the 0 position.
If you encounter problems, refer to the troubleshooting guide for other instructions. If needed, contact the
appropriate Horizon Hobby Product Support of ce.
To bind your mCP X BL to your chosen transmitter, follow the directions below:
To Next Page
Loading...
Need help?
General
