EN
Program your transmitter to set the rates and control throws based on your
experience level.
After ying, you may choose to adjust the values for the desired control response.
Horns Arms
Aileron
Elevator
Rudder
Flaps
The table to the right shows the factory settings for the control horns and servo arms.
These settings, in conjunction with the low rate transmitter settings, are intended for
intermediate level pilots to help ensure a successful ight.
Fly the aircraft at these factory settings before making changes.
Nose
Wheel
10
Twin Otter 1.2m
Control Surface Direction
Power on the transmitter and connect the battery. Use the transmitter to
operate the aileron and elevator controls. View the aircraft from the rear when
checking the control directions.
Ailerons
1. Move the aileron stick to the left. The right aileron should move down and
the left aileron up, which will cause the aircraft to bank left.
2. Move the aileron stick to the right. The right aileron should move up and
the left aileron down, which will cause the aircraft to bank right.
Aileron stick
Rudder stick
Elevator stick
Elevators
1. Pull the elevator stick back. The elevators should move up, which will
cause the aircraft to pitch up.
2. Push the elevator stick forward. The elevators should move down, which
will cause the aircraft to pitch down.
Rudder
1. Move the rudder stick to the left. The rudder should move to the left,
which will cause the aircraft to yaw left.
2. Move the rudder stick to the right. The rudder should move to the right,
which will cause the aircraft to yaw right.
Dual Rates and Control Throws
Low Rate High Rate
Aileron 8mm 12mm
Elevator 8mm 12mm
Rudder 10mm 20mm
Flap Travel
Half q = 10mm
Full q = 20mm
To Next Page
Loading...
Need help?
General
