EN
11
AS3X Control Direction Test (BNF)
This test ensures that the AS3X
®
control system is functioning properly.
Assemble the aircraft and bind your transmitter to the receiver before
performing this test.
1. Raise the throttle just above 25%, then lower the throttle to
activate AS3X technology.
CAUTION: Keep all body parts, hair and loose clothing away from a
moving propeller, as these items could become entangled.
2. Move the entire aircraft as shown and ensure the control surfaces move in
the direction indicated in the graphic. If the control surfaces do not respond
as shown, do not y the aircraft. Refer to the receiver manual for more
information.
Once the AS3X system is active, control surfaces may move rapidly. This is normal.
AS3X remains active until the battery is disconnected.
During your rst ight, trim the aircraft for level ight at 1/2 throttle with aps up.
Make small trim adjustments with your transmitter’s trim switches to straighten the
aircraft’s ight path.
After adjusting the trim, do not touch the control sticks for 3 seconds. This allows
the receiver to learn the correct settings to optimize AS3X performance. Failure to
do so could affect ight performance.
In Flight Trimming (BNF)
Aircraft
movement
AS3X Reaction
ElevatorAileronRudder
3 Seconds
To Next Page
Loading...
Need help?
General
