Need help?Do you have a question about the Horizon Reverse Osmosis Seafari Quest Compact 200 and is the answer not in the manual?
General| Type | Reverse Osmosis Watermaker |
|---|---|
| Model | Seafari Quest Compact 200 |
| Salinity | Up to 35, 000 ppm |
| Operating Pressure | 800 psi |
| Production Rate | 200 gallons per day |
| Pre-Filtration | 5 Micron Sediment Filter |
| Post-Filtration | Carbon Filter |
| Housing Material | Stainless Steel |
| Connection Type | Quick Connect |
Explains the manual's intent for technicians and operators. Covers installation, operation, maintenance, and troubleshooting.
Disclaimer regarding information accuracy and potential damages from instructions.
Details changes and updates made to the manual over time.
Lists available compact and modular models of the Seafari Quest system.
Advises against using non-Horizon Reverse Osmosis parts to prevent failures and warranty voidance.
Emphasizes reading and complying with safety requirements during operation and maintenance.
Details system specifications for feed water and recovery rates.
Outlines operating pressure requirements and measurements for the system.
Provides performance data for different models, including water production.
Describes the system's pre-filtration stage and its components.
Explains the components responsible for pressurizing water for RO.
Details components that process and filter product water.
Provides instructions and guidelines for making proper plumbing connections.
Warns about chemical handling and potential damage to RO membrane.
Lists critical checks before operating or maintaining the system.
Specifies the required technical expertise for system installation.
Guides on properly mounting system components for accessibility and stability.
Provides instructions for making correct electrical connections to the system.
Details the procedure for installing the UV sterilizer unit.
Step-by-step guide for initial system start-up and commissioning.
Form for recording initial system parameters for reference.
Instructions for daily system start-up and checks.
Explains the functions of the system's control buttons and interface.
Provides critical warnings for handling and storing RO membrane elements.
Details the methods and requirements for cleaning RO membrane elements.
Describes causes and solutions for high-pressure fault errors.
Explains causes and troubleshooting steps for low-pressure faults.
Discusses issues arising from mismatched system components.
Outlines the necessary electrical specifications for system operation.
Details voltage and frequency requirements for different system configurations.
Exploded view and parts list for the modular system.
Exploded view and parts list for the compact system.
Exploded view and parts list for the sea strainer assembly.
Exploded view and parts list for the ETD-PUMP assembly.
Exploded view and parts list for the pH neutralizer assembly.
To Next Page