CALIBRATION MANUAL
1. THE FIRMWARE UPGRADE
A) HOROTEC
©
Flashtest
- Connection PC
HOROTEC
©
Flashtest
can be connected to a PC and the
Firmware can be downloaded via HOROTEC
©
Flashtest
- PC
connection. For the HOROTEC
©
Flashtest
- PC connection,
download the HOROTEC
©
Flashtest
PC Application Installer
via Internet www.horotec.ch.
B) Downloading HOROTEC
©
Flashtest
FIRMWARE
To open the next menu (See figure below), click on the Support
menu of the website www.horotec.ch (NOTE : internet connection
is essential for this operation!)
C) Downloading the application SOFTWARE
Click on the FLASHTEST PC Application Installer you can find on
the Horometer website (www.horotec.ch) (NOTE : Some browsers
such as Chrome, do not support downloading from the Internet.
If the download does not succeed, check your browser and use
Internet Explorer or Mozilla Firefox.)
D) FIRMWARE UPGRADE
HOROTEC
©
Flashtest
contains the latest software and
documentation available at the time the package was assembled.
There may be newer software available or dependencies that
require special attention to product version number. To ensure
proper installation, operation checks online documentation from
the web site www.horotec.ch before using the product. The download
of new software versions via internet is simple, quick and free of
charge :
1) Switch ON and connect your
HOROTEC
©
Flashtest to the
PC with the special cable available optionally.
4
GB
To Next Page
Need help?
General
