TThhee ssiimmppllee iinnssttrruuccttiioonnss bbeellooww aarree ddeessiiggnneedd ttoo hheellpp wwiitthh tthhee pprrooggrraammmmiinngg ooff tthhee uunniitt..
Electronic equipment can in some circumstances be affected by electrical interference. If the
programmer’s display becomes frozen or scrambled; or if you wish to revert back to the default time
settings please use the following procedure.
SETTING DAY AND TIME OF DAY
Should you encounter any problems, please refer to the
QQuueessttiioonn aanndd AAnnsswweerr
section located on page 4.
RESETTING THE PROGRAMMER
Press SELECT once.
Programme goes from
AUTO to ALL DAY
Press SELECT again.
Programme goes from
ALL DAY to 24 HRS
Press SELECT again.
Programme goes from
24 HRS to OFF
Press SELECT again.
Programme goes from
OFF to AUTO
Unit will operate from
first ON until last OFF
period
Unit will be
continuously ON
Unitl will be
continuously OFF
Programmer will return
to normal ON and OFF
times
BOOST FUNCTION
- 1hour temporary override
ADVANCE FUNCTION - Brings forward next on or off operation
INFORMATION AND ADVICE
PPaaggee 22
PPaaggee 33
Press the SET but-
ton until the SET indi-
cator is next to the
CLOCK position.
Use
PLUS and
MINUS
buttons to
adjust time
Use PLUS
and MINUS
buttons to
adjust day
Press
ENTER
Press SET button
until the SET indicator is
next to the PROG
position
Repeat this
process for 2nd
and 3rd settings
Press
ENTER
Press
ENTER
Press
ENTER
SETTING THE ON AND OFF TIMES
The SET indicator must remain in the RUN position for the following instructions.
SPECIAL FEATURES
Use PLUS
and MINUS but-
tons to adjust
day
Use PLUS and
MINUS
buttons to adjust
the 1st ON time.
Use the PLUS
and MINUS but-
tons to adjust the
1st OFF time.
Programme the
remaining days.
If you require this
programme on any other
day of the week use the
PLUS and MINUS buttons to
select day and press COPY
Press the SET but-
ton until the SET indi-
cator is next to the
RUN position.
Press
ENTER
Press SET button
until the SET
indicator is returned
to RUN position
6:35
M T W T F S Su
M T W T F S Su
SET
SELECT
M T W T F S Su
M T W T F S Su
M T W T F S Su
M T W T F S Su
M T W T F S Su
AUTO
ALL DAY
24 HRS
OFF
AUTO
ALL DAY
24 HRS
OFF
AUTO
ALL DAY
24 HRS
OFF
AUTO
ALL DAY
24 HRS
OFF
PM
12:00
PM
RUN
CLOCK
PROG
M T W T F S Su
DAY
RUN
CLOCK
PROG
M T W T F S Su
6:30
AM
RUN
CLOCK PROG
RUN
CLOCK
PROG
6:35
PM
6:35
PM
6:35
PM
6:35
PM
AUTO
ALL DAY
24 HRS
OFF
6:35
PM
RUN
CLOCK
PROG
BOOST
M T W T F S Su
AUTO
ALL DAY
24 HRS
OFF
6:35
PM
RUN
CLOCK
PROG
ADVANCE
At any time during a BOOST
period press BOOST again to
return to normal program-
ming
Press BOOST button:
Your System will be Boosted
for 1 hour
Press ADVANCE button once
to move to the next
ON/OFF time
To cancel the advance press the ADVANCE
button again. This will return the unit to
its normal programme
Programming ON/OFF times
If a period is not required it can be cancelled by setting the ON and OFF settings to the same
time. Example ON 10:00am OFF 10:00am
Press the SET and SELECT buttons together
then release the buttons and the programmer
will return to preset factory settings.
1ON
MON-FRI
SAT/SUN
1st ON 1st OFF 2nd ON 2nd OFF 3rd ON 3rd OFF
6:30
AAMM
8:30
AAMM
12:00
PPMM
12:00
PPMM
4:30
PPMM
10:30
PPMM
7:30
AAMM
10:30
AAMM
12:00
PPMM
12:00
PPMM
5:00
PPMM
11:00
PPMM
DDEEFFAAUULLTT TTIIMMEE SSEETTTTIINNGGSS
The default factory settings
are shown, however if you
wish to change these
proceed as instructed below.
To Previous Page
Loading...
