Hoshizaki DCM-300BAH Cleaning & Sanitizing

Cleaning Prep:
Close the water supply line shut-off valve,
move the dispense mode switch to
CONTINUOUS
and dispense all the ice
from the storage bin.
Move the control switch to DRAIN. Allow the icemaker to
drain for 5 minutes. Move the control switch to OFF.
If the unit is running, there will be a 2.5 minute delay before the drain valve will open.
Remove the Front Panel* and Top Panel. Move the
power switch to OFF.
*Push-button models: Take care in disconnecting the button connector.
Cleaning:
Dilute Hoshizaki Scale Away with warm water (see Table below). Remove the
Storage Bin Cover**, Spout B, then Spout A. Pour
cleaning solution into the Extruding Head until the
Evaporator Assembly and the Reservoir are full
and the solution overflows into the Drain Pan. Replace Spout A &
B, and the Storage Bin Cover.
Allow the icemaker to soak for 10 minutes.
**Use a 15mm socket to easily remove thumb screws.
In bad water conditions, a more thorough cleaning may be
required. Remove the Float Switch from the Reservoir cover.
Clean the Float Switch with the solution, rinse thoroughly with
clean water, and replace it back in the cover. In addition to
following Step ❹, place a clamp on the Reservoir hose that will
block the flow to the evaporator assembly. Pour additional
cleaning solution over the Extruding Head until the Evaporator
Assembly is full. Allow to soak, remove the clamp before
operation. Otherwise, continue to Step ❻.
DCM-300, DCM-500
Scale Away
9.6 fl. oz (0.29 l)
Warm Water
1.6 gal. (6.0 l)
Power Switch
Control Switch
Ice Machine
DCM-300BAH(-OS)
DCM-500BAH(-OS)
DCM-500BWH(-OS)
Sanitizing:
• Dilute 5.25% chlorine
bleach
‡
with warm water
(see Table below)
DCM-300, DCM-500
Bleach
0.82 fl. oz (25 ml)
Warm Water
1.6 gal. (6.0 l)
‡ Use bleach without additives.
• Remove the front and top
panels
• Move the power switch to OFF
• Remove the storage bin
cover, spout B, then spout A
• Pour the sanitizing solution
over the extruding head until
solution starts to overflow
into the drain pan
• Clean, rinse, and replace
spout A, spout B, and the
storage bin cover
• Allow the icemaker to soak
for 10 minutes
• Move power switch to ON,
replace the panels
• Move the control switch to
ICE
• Make ice with the solution until
it stops, dispose of ice
• Move the control switch to
DRAIN
• Allow the icemaker to drain for
5 minutes
Cleaning & Sanitizing
AMMONIA
Cleaners
The icemaker/dispenser must be cleaned & sanitized at least twice a year.
ATTENTION!
Do not leave icemaker
unattended when panels are off
Tech Support: 1.800.233.1940
1
2
3
4
11
12
13
14
15
5
16
#51051 | 04.11.22
Page 1
Top
Right Side
Front of
icemaker
Button models
To Icemaker
Or Water Filter
SHUT OFF
REMOVE ICE
CLEAN
Dispense Mode Switch
Safety Switch
Evaporator
Assembly
Wait
5 min.
 continued on the back…
Pour Solution into
Extruding Head
17

Hoshizaki DCM-300BAH Specifications

General

Brand	Hoshizaki
Model	DCM-300BAH
Category	Ice Maker
Language	English