02
02 Instructions
Usage
Charging
This product can be used with 7mm-diameter hot melt glue
sticks (HOTO hot melt glue sticks are preferred) to bond
plastics, wood, paper products, textiles, ceramics, glass,
leather, crystal items, shells, etc.
• In "O" state, press and hold the "On/o" button for 3
seconds to power on the product.
• In "On" state, press and hold the "On/o" button for 3
• If the product is let rest for 5 minutes, it will automatically
• Power on the product, insert a glue stick, wait (for about 30
seconds) until the state indicator light is long on (indicating
that preheating is completed), and press the glue output
button to output glue.
• Spread the glue to the item to be bonded, and press it until
the glue sets. Bonding is thus completed.
• Charge the product by connecting it to the charger with a
Type-C charger cable.
• If the product has been idle for a long time, fully charge it
before use.
•
To Next Page
Loading...