EasyManua.ls Logo

Hotpoint Ariston ARTL 82 - Washing Machine Operation; Control Panel Overview; Indicator Lights Explained

Hotpoint Ariston ARTL 82
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
GB
Standby mode
This washing machine, in compliance with new energy
saving regulations, is fitted with an automatic standby
system which is enabled after about 30 minutes if no
activity is detected. Press the ON-OFF button briefly
and wait for the machine to start up again.
Indicator lights
The indicator lights provide important information.
This is what they can tell you:
Wash cycle phase indicator lights
Once the desired wash cycle has been selected and
has begun, the indicator lights switch on one by one
to indicate which phase of the cycle is currently in
progress.
Function buttons and corresponding indicator lights
When a function is selected, the corresponding
indicator light will illuminate. If the selected function is
not compatible with the programmed wash cycle, the
corresponding indicator light will flash and the function
will not be activated. If a function which is incompatible
with another function selected previously, only the most
recent selection will remain active.
Wash
Rinse
Spin
Drain
End of wash cycle
ON/OFF button: switches the washing machine on
and off.
WASH CYCLE knob: programmes the wash cycles.
During the wash cycle, the knob does not move.
FUNCTION buttons with indicator light: used to
select the available functions. The indicator light
corresponding to the selected function will remain lit.
TEMPERATURE knob: sets the temperature or the
cold wash cycle (see Personalisation).
WASH CYCLE PROGRESS
indicator light
s: used to monitor the progress of the
wash cycle. The illuminated indicator light shows
which phase is in progress.
LID LOCKED indicator light: indicates whether the
door may be opened or not (see next page).
START/PAUSE button with indicator light: starts or
temporarily interrupts the wash cycles.
N.B. To pause the wash cycle in progress, press this
button; the corresponding indicator light will flash
orange, while the indicator light for the current wash
cycle phase will remain lit in a fixed manner. If the LID
LOCKED
indicator light is switched off, the door
may be opened.
To start the wash cycle from the point at which it was
interrupted, press this button again.
Description of the washing machine
and starting a wash cycle
TEMPERATURE
knob
WASH CYCLE PROGRESS
indicator lights
FUNCTION
buttons with
indicator lights
ON/OFF
button
LID LOCKED
indicator light
START/PAUSE
button with indicator
light
Control panel
WASH CYCLE
knob

Related product manuals