Solid Sbte Monitor System
It keeps an eye on
things for you.
9?
9
?
9
@Red signal lightflashes to tell
you when either door is open.
@Signal lighttellsyou that the
Door Alarm beeper has been set to
sound after either door has been
open 30 seconds.
@Red signal light tells you when
freezer
foodkeeping
temperature is
above normal.
@Lighted word NORMAL
indicates that no failure has been
detected by the diagnostic system.
@Flashing diagnostic codes in the
display warn you when:
❑
frozen foods should be
checked.
❑
power has been interrupted.
❑
icemaker may not be operating
properly.
❑
defrost system has failed.
❑
freezer control may need to be
set for a colder temperature.
What these codes mean—and
what to do when they appear—is
summarized on the inside of the
freezer compartment door and
explained more thoroughly on
the following pages.
@STATUS
CHECKpadputsa
review of the electronic diagnosis
of five coded functions at your
fingertip and also allows you to
erase codes and reset the display.
@
Electronic control allows you
to turn night light in water-and-ice
service on and off.
@
Electronic control allows you to
select ice cubes or crushed ice, and
signal light confirms your choice.
When your refrigerator
is
first
plugged in...
All panel lights come on for five
seconds, a beep sounds, and lights
go off except as follows:
●
PF
flashes in the display. Touch
STATUS CHECK-RESET pad to
erase it.
●
Word NORMAL glows.
c
Red WARM TEMPERATURE
light glows if freezer compartment
temperature is higher than normal.
It goes off when proper
foodkeeping
temperature is reached.
● Door alarm beeper is activated
and light on DOOR ALARM
pad glows.
● CRUSHED ice selection light
glows.
● Red DOOR OPEN light flashes if
either door is open, goes out when
doors are shut.
●
Night light in water-and-ice
service is off.
6
To Next Page
Loading...
Need help?
General
