,,
~
~Q.~. ,x+
*“2~~m
,:~
:3.?;yj?~=:~’f#~PL3.!. .
..: .
...”- L!’ : ~... s
.:
.&@causeot p&ent& sava~ynazards
undercertain conditions, westrongly
recommendagainstuseof anadapter
plug. However, if you still elect to use
anadapter,where local codespermit,
aTENIPORN?YCONNECTION may
bemadeto aproperly grounded
two-prong wall receptacle by usbof
a UL listed adapter (Fig. 2)available
at most local hardware stores.
TEiMPOHAllYMETHOD
(ADAPTERPLUGSNOT
PERMITTEDINCANADA)
m
~ Fig.2 ~]
BEFOREUSE
The larger slot in the adapter must be
aligned with the Iargerslot in the wall
receptacle to provide proper polarity
in the connection of the power cord.
CAUTION: Attaching adapter
ground terminal to wall receptacle
cover screw does not ground the
appliance unless cover screw is
metal, and not insulated, and wall
receptacle is grounded through
house wiring, Customer should
have the circuit checked by a qual-
ified electrician to make sure the
receptacle is properly grounded.
W/hendisconnectingthe power
cordfromthe adapter, always hold
the adapter with one hand. If this
is not done, the adapter ground
terminal is very likely to break
with repeated use.
SIWLNCIthe adapter gKNu?d
terminal break, DO NOT USE the
a~piianceuntil a properground
hasagain been established.
?
:’J-r. p ,“%$ ,~,,, F,--*.>..:.. ~
,,-p
*>F ,, .,: ,,
.
,,
:
$,”.>j.+>f,::,i,jf, (:iy”f--:;
Because of potential safety hazards
under certain conditions, westrongly
recommend against the useof an
extension cord. However, if you still
elect to usean extension cord, it is
absolutely necessarythat it be a UL
listed 3-wire grounding type appli-
ance extension cord and that the
current carrying rating of the cord be
15amperes minimum. Such exten-
sion cords are obtainable through
your local service organization.
This is recommended for best
performance and to prevent over-
loading house wiring circuits,
which could cause a possible fire
hazardfrom overheating wires.
Do not installrefrigeratorwhere
temperaturewH$go Mow 60°F.
because it will not run often enough
to maintain proper temperatures.
Doinstallit cma floorstrongenough
tosupportafullyloadedrefrigerator.
Also see Energy-Saving Tips
regarding location.
.-:.
7+,’).:;. -.
.!. -,
:--p
:l;j+$-~+ ,,, ~
. .. . .
d. :22 a KTf%%vhixw ..“
.J~.’.;:::~. ;i.,+.
consider providing water supply to
refrigerator location. It will simplify
connection of optional automatic
icetmaker should you wish to install
one at a later date.
F-Y .. ~: ‘ .-?$,<.,, “$-,{2ii ,’:<,g’c’
$Wt.hiww’k
.rk,:..? “$
1.... -4-- k;
Adjustablerdkrs {on models so
equipped) which enable you to
move refrigerator awayfrom wailfor
cleaning, or kwding legs,are
located behind basegrille. They
should beset sorefrigerate_is
firmly positioned onfloor andfront is
raisedjust enough that doors close
easily when opened about halfway.
Toadjustrollersor levelinglegs,
remove base grille by grasping it
at bottom and pulling it out.
ROLLER
ADJUSTINGSCREW
\
-L
k
&
o
Turn roller adjusting screws or
leveling legs clockwise to raise
refrigerator, counterclockwiseto
lower it. Use adjustable wrench or
pliers onthe roller adjusting screw’s
3/8” hex head bolt.
When adjusting rollers or leveling
legs for proper door closure} bottom
front edge of cabinet should be
approximately 5/8” from floor’.
I
Toreplace base gri!le, align prongs
on back of grille with clamps in
cabinet and push forward until
grille snaps into place.
To Next Page
Loading...
Need help?
General
