shelves
Shelfsupportsat variouslevels
enableyou to repositionthe shelves
to betteraccomnlodateyourvariable
inventoryof refrigeratedfoods.
Half-Widtl]SheIves
(on
modelssoequipped)
11%1
I
~
TiltUp
One end rests on a moldedside-
wailsupport: a bracketon the other
end hoois into a trackon the rear
cabinet wall.
To remove, Iift the shelf upat
front, then off the support and out
of the track.
To replace, select desired shelf
height. With shelf front raised
slightly,hook the bracket’stop lug
into the track, then lower the shelf
onto the support.
fill-Width Shelves
(onmodelssoequipped)
The full-widthshelfhaswireloops
near each rear corner thatfitinto
pocketsin theshelfsupportsto
holdthe shelf securelyin place.
Toremovethe shelf, lifttherear
ofthe shelf and pull forward.
Toremovea full-widthshelf
whenthe freshfoodcompartment
doorcannot be opened fully...
.lift the rear of the shelf. pull
fjrward and down, tilt the shelfand
take it out.
FreezerComoartn~ent
shelves
‘
(onmodelssoequipped)
Somemodelshavean ice-tray
.,. . . . . . .,-.
shelf, some have a lower-level shell
tothe right ofthe ice tray shelf and
somemodelshavea full-widthstep
shelf.
To removethe ice-trayshelf when
it’sthe only shelfin the freezer
compartment, liftthe rightside up
offhooksat top, then pull shelf to
the right to free itspins from holes
in the cabinet wall.
Toremovethe ice trayshelf and
the wire shelf next to-it:
1. Takethe ice-trayshelf aridlift its
right side up off hooks at top.
-.
2. Takethe wire shelf and lift its
leftside up off hooks at top.
3. Swing the wire shelf clear of the
hooksand the ice-tray shelf and
pull it to the leftto free itspins
from holes in thecabinet wall.
4. Swing the ice-tray shelf clown
and pull itto the right to free its
pins fronl holes in the cabinel wall. :
:.
L,
~.
To Next Page
Loading...
