8 of 27
Service Manual UK
Indesit
Company
English
Connecting the water inlet hose.
Before making the water
connection to the 3/4"
thread, allow the water
freely from the supply tap
until it is perfectly clear.
Check that seal is in place
inside the hose end cap.
Connect the other end of
the water inlet hose to the
washing machine,
screwing it onto the cold
water inlet, situated on the
top right-hand rear of the
appliance - see
illustration.
Screw the inlet end with the blue cap onto the cold water supply tap.
Turn the tap on and check for leaks: tighten if necessary.
Make sure there are no kinks or bends in the hose.
The water pressure at the tap must be within the values indicated in the
Specifications page.
To Next Page
Loading...
