Hott C229 - Page 10

※ Important notes:
The power adapter for this product is of USB 5V-2A supply voltage. Using an adapter with a voltage
higher than 5V to charge this product can damage the internal chip of the device, rendering it unusable.
1. When the screen displays Lo, please recharge the CD player as soon as possible;
2. We recommend using a 5V-2A charging adapter and the provided USB cable to charge the CD
player.
During charging, the indicator light will turn constant red. When fully charged (approximately 3 hours),
the indicator light will turn constant blue.
FAQs
Abnormality
Possible causes
Solution
Unable to power on
the product
Low battery
Charge the product using the
provided USB cable (adapter
output 5V2A)
Unable to read discs
Check the disc for severe scratches, marks,
cracks, fingerprints, or dirt
Replace the disc with a newer or
cleaner one
Check if the disc format is one of those
supported by the CD player
Substitute a format supported by
the CD player
No sound
Headphones are not plugged into the jack
properly;
Re-plug or replace the headphones
Check if the volume of the CD player has
been turned to the lowest
Turn up the volume by using the
volume knob
Unable to charge
Poor quality of USB port or USB cable
Replace the USB cable
Unable to connect to
Bluetooth devices
The device being paired is not in Bluetooth
pairing mode
The CD player and the device
paired should be in Bluetooth
pairing mode concurrently.
The device being connected is beyond the
effective connection range of Bluetooth
Get the device closer and
reconnect
The play stops or
the device shuts
down automatically
Check if the play mode is ALL (All songs
on loop)
If it’s not set, the CD player will
stop or shut down automatically
upon playing the songs
Some songs are
skipped
Check if the disc is dirty or bears scratches.
Replace the disc
OPEN is displayed
The top cover is not closed
Close the top cover
NoCD is displayed
The disc is not read or is absent
Load the disc again