Maintenance guide - Chairs
4
Everyday Cleaning:
Suaces can be easily cleaned with a dry or damp cloth and
if necessary, a mild household cleaner. All-purpose cleaner,
household cleaners, water or soap are recommended. It is
resistant to everyday wear and tear but needs some atten-
tion for harsh conditions and staining.
Thorough Cleaning:
Review suppliers’ instructions for further cleaning on diicult
stains. Do not use abrasive or polishing materials, abrasive
cleaners, scourer pads, bleaches, wire wool or sandpaper.
High pressure water cleaning or steam cleaning of panels is
not recommended. Don’t use any product containing strong
mineral acid such as sulfuric acid, battery acid, hydrochlo-
ric acid, nitric acid or phosphoric acid. Care must be taken
where cleaning agents or solvents are highly acidic or alka-
line as these may permanently damage the suace.
Veneer
General Maintenance:
Always protect suaces against heat, damp or color bleed-
ing objects. Do not place furniture directly against radiators
or heaters.
To preserve the colors of the material, keep out of direct
sunlight. In addition to light, extremely high or low humidity
is a damaging environmental factor.
Everyday Cleaning:
For basic cleaning use a clean, slightly damp, nonabrasive
cloth with cleaner formulated for wood furniture. Wipe dry
with a dry, so cloth in the direction of the wood grain.
Do not use aerosol-powered cleaners or polishes. Spills and
dampness should be cleaned promptly and not allowed to
air dry.
Thorough Cleaning:
Detailed cleaning should be completed at least once a
year. Apply a quality furniture polish with a clean, so cloth
to maintain the suace. Avoid using aerosol-powered
cleaners or polishes. Do not use polishes containing waxes
or abrasives, or oil-based polishes. Verify cleaner used is
appropriate for the type of wood to prevent changes to the
color of the wood or treatment.
Scratches can be repaired with the use of a scratch-remov-
ing polish the appropriate color for the veneer. If in doubt
about the suitability of a particular cleaner or polish, check
with the manufacturer of the cleaning product.
Maintenance & Inspection
It is recommended that owners/users conduct a visual and
physical examination of this product at least once every 3
months (more frequently where product subject to heavy
use) to check on the stability and integrity of the product,
with inspections to include a thorough examination of all
fasteners, screws, welds, joints, and glue points to check
for cracks, looseness, signs of instability, etc. The product
should be taken out of service immediately if any such con-
dition is discovered.
This Maintenance & Inspection instruction is also shown on
a label underneath the product.
To Next Page
Loading...