5
Water will flow for 60 minutes maximum or until
it is turned off. The LED will flash green when
watering occurs.
Note: After 60 minutes water shuts off
automatically. Automatic watering will continue
normally unless the dial is turned to the OFF
position.
MANUAL OFF
Press the water now button again at any
time and the valve will close. The led will stop
flashing.
Note: To protect battery life the water
controller can only be turned on and off
CONNECTING THE TIMER TO THE TAP
Use supplied adaptors if required.
Hand tighten firmly to ensure no leaks. Do not
use a wrench or other tool to tighten the nuts
as this can permanently damage the plastic
components
BATTERY CHECK FUNCTION
BATTERY CHECK FUNCTION
To check the status of the installed batteries simply
press and hold down the water now button.
GREEN LED BATTERIES ARE OK
RED LED BATTERIES NEED TO BE
REPLACED WITH NEW ONES.
See “CHANGING THE
BATTERIES” section.
FAILURE PREVENTION MODE
A built in safety feature detects when the
battery levels have dropped to a level that could
fail whilst the valve is open and result in wasting
water.
The safety mode prevents the controller
from turning on until the batteries have been
replaced.
The LED indicator light will flash red when the
failure prevention mode has been activated.
The water now function will also not operate
until the batteries have been replaced.
CHANGING THE BATTERIES
When changing the batteries remove the old
ones then wait 20 seconds before putting the
new batteries in.
PROGRAM SELECTION STICKER
Your Select Timer is supplied with stickers to
help you select the correct programs. Attach
the sticker to the body behind the front panel as
shown.
To Next Page
Loading...
