Rack Air Duct kit 96
d.
Repeat steps a through c for the left-side assembly.
2. Install the top assembly of the rear extension assembly.
a. Align the top assembly with the installed side assemblies (1).
b. Using a T-25 Torx driver, insert and tighten two M6 machine screws into the rear screw holes (2).
c. Using a T-25 Torx driver, insert and tighten two M6 machine screws into the front screw holes (3).
3. Install the bottom assembly of the rear extension assembly.
a. Align the bottom assembly with the installed side assemblies (1), making sure to set the metal tab at
the front of the assembly over the rear rack frame (2).
To Next Page
Loading...
