Index
|
Administrators Guide
|
Users Guide
|
Tool Overview
|
Related Documents
|
Dictionary
Copyright 1994-2004 hewlet
-
ackard company
To install a CPACK-FILES bundle on an individual compute node, or group of compute nodes,
the clsh utility can be used:
%
/opt/clusterpack/bin/clsh -C <node(s)> "/usr/sbin/swinstall -s
<manager_ip>:/var/opt/clusterpack/depot <CPACK-FILES bundle
version>"
References:
z
3.1.5 clsh - Runs commands on one, some, or all nodes in the cluster.
z
1.5.4 Adding software bundles to Golden Images
Back to Top
1.5.4 Adding software bundles to Golden Images
Software bundles created with SD can be asociated with a Golden Image, and will be installed
on the compute nodes following an installation with that image. The software bundles should
be swcopy'd to /var/opt/clusterpack/depot. A list of all the bundels that are available in the
depot can be found using:e
% /usr/sbin/swlist -l bundle @ /var/opt/clusterpack/depot
The bundles are associated with an image using the sysimage_register command:
% /opt/clusterpack/bin/sysimage_register -i <image> -b <bundle>
The "-
bundle" option can be repeated on the command line to associate additional SD bundles
to the image. The bundles will remain associated with the image until sysimage_register is run
again. The bundle should include the full revision of the bundle (i.e. bundle,r=revision), to
avoid conflicts during installation.
Back to Top
To Next Page
Loading...
Need help?
General