After adding, removing or modifying queues, it is necessary to reconfigure LSF to read the new
queue information. This is done from the Management Server using the Clusterware Pro V5.1
CLI:
% badmin reconfig
Verify the queue has been added by using the Clusterware Pro V5.1 CLI:
%
bqueues -l <queue_name>
References:
z
3.7.9 How do I access the Clusterware Pro V5.1 Command Line Interface?
Back to Top
1.8.2 Remove Queues
A queue can be removed from the cluster by editing the
file: /share/platform/clusterware/conf/lsbatch/<clustername>/configdir/lsb.queues
The name of your cluster can be determined by using the Clusterware Pro V5.1 CLI:
%
lsid
Before removing a queue, it should be closed using the Clusterware Pro V5.1 CLI:
% badmin qclose <queue name>
Jobs still executing can be killed or allowed to run to completion before removing the queue.
Delete or comment out the queue definitions that you want to remove.
After adding, removing or modifying queues, it is necessary to reconfigure LSF to read the new
queue information. This is done from the Management Server using the Clusterware Pro V5.1
CLI:
%
badmin reconfig
Verify the queue has been removed by using the Clusterware Pro V5.1 CLI:
% bqueues -l <queue_name>
References:
z
1.8.1 Add new Job Submission Queues
z
3.7.9 How do I access the Clusterware Pro V5.1 Command Line Interface?
To Next Page
Loading...
Need help?
General