HP 10S

m Error Messages
If an error message occurs, the calculator stops running
immediately. Press[ac] to clear the error message, or
press[]or [>] to redisplay the calculation so that you can
correct it.
Math ERROR
Causes elThe result exceeds the calculator's
computational range.
®You tried to enter a value that exceeds the
calculator's input range.
@The operation requested is not mathematically
valid (for example, dividing by 0).
Correction e Check that the input value is within the allowable
input range. If you are using memory variables,
check that the stored values will not cause the
calculator to exceed its computational range.
Stack ERROR
Causes eThe capacity of the number stack or
operator stack has been exceeded. The
number stack can have 10 levels while the
operator stack can have 24.
Correction@Simplify the calculation.
eBreak up the calculation into two or more parts.
Syntax ERROR
Causes The number entered or operator selected was
not expected or was not in the correct form.
CorrectionePress [<4] or [&] to redisplay the calculation.
The cursor will be at the place where the
error occurred. Correct the problem and
then proceed.
Arg ERROR
Causes The parameter you entered was not expected
or was not in the correct form.
Correction ePress [4] or (®] to redisplay the calculation.
The cursor will be at the place where the error
occurred. Correct the problem and then
proceed.
30