2. Remove the memory module (2) by pulling it away from the slot at an angle.
Reverse this procedure to install a memory module.
Solid-state drive
To remove the solid-state drive, use this procedure and illustration.
Table 5-7 Solid-state drive descriptions and part numbers
Description Spare part number
256 GB, PCIe L85354-005
128 GB, PCIe, TLC M06792-005
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 32).
2. Remove the rubber feet (see Computer feet on page 32).
3. Remove the bottom cover (see Bottom cover on page 33).
4. Remove the battery (see Battery on page 35).
Remove the solid-state drive:
1. Remove the Phillips M2.0 × 2.0 screw (1) that secures the drive to the system board.
2. Remove the drive (2) by pulling it away from the connector.
NOTE: Solid-state drives are designed with notches to prevent incorrect insertion.
40 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
