3. Lift the speakers out of the computer (3).
Reverse this procedure to install the speakers.
Power connector
To remove the power connector, use this procedure and illustration.
Table 5-9 Power connector description and part number
Description Spare part number
Power connector L23188-001
Before removing the power connector, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 32).
2. Remove the rubber feet (see Computer feet on page 32).
3. Remove the bottom cover (see Bottom cover on page 33).
4. Remove the battery (see Battery on page 35).
5. Remove the right hinge screw and lift the right hinge (see Display assembly on page 51).
Remove the power connector:
1. Disconnect the power connector cable
(1) from the system board.
42 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
