2. Lift the power connector (2) to remove it.
Reverse this procedure to install the power connector.
Touchpad click board
To remove the touchpad click board, use this procedure and illustration.
Table 5-10 Touchpad click board part descriptions and part numbers
Description Spare part number
Touchpad click board L24486-001
Touchpad board cable L23184-001
Touchpad click board cable L24485-001
Before removing the touchpad click board, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 32).
2. Remove the rubber feet (see Computer feet on page 32).
3. Remove the bottom cover (see Bottom cover on page 33).
4. Remove the battery (see Battery on page 35).
To remove the touchpad click board:
1. Disconnect the touchpad cable (1) from the system board, and then disconnect from the touchpad click
board cable (2) touchpad.
2. Remove the two Phillips M2.0 × 2.0 screws (3)
that secure the touchpad click board to the computer.
Touchpad click board 43
To Next Page
Loading...
