3. Lift the board (4), and then slide it outward from under the clips that hold it on place to remove it (5).
TIP: The edge of the board sits under clips. Be sure to slide the board out from under the clips to
prevent damage to the board or clips.
Reverse this procedure to install the touchpad click board.
Touchpad
To remove the touchpad, use this procedure and illustration.
Table 5-11 TouchPad description and part number
Description Spare part number
Touchpad L24484-001
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 32).
2. Remove the rubber feet (see Computer feet on page 32).
3. Remove the bottom cover (see Bottom cover on page 33).
4. Remove the battery (see Battery on page 35).
5. Remove the touchpad click board (see Touchpad click board on page 43).
To remove the touchpad click board:
1. Peel the conductive tape
o the keyboard (1).
44 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
