●
Top cover (see
Top cover on page 57)
●
Speakers (see
Speakers on page 65)
●
USB board (see
USB board on page 67)
●
Power connector cable (see
Power connector cable on page 69)
●
Display assembly (see
Display assembly on page 71)
●
System board (see
System board on page 80)
●
Fan/heat sink assembly (see
Fan/heat sink assembly on page 86)
To remove the processor:
1. Use a flat-bladed screw driver (1) to turn the processor locking screw one-half turn
counterclockwise (2) until you hear a click.
2. Lift the processor (3) straight up, and then remove it.
NOTE: The gold triangle (4) on the processor must be aligned with the triangle icon embossed on the
processor socket when you install the processor.
Reverse this procedure to install the processor.
ENWW Component replacement procedures 91
To Next Page
Loading...
