4-22 Display Codes
Table 4-18. MPE/iX ISL Boot Codes
Code Description
CE40 MMSAVE Launched
CE41 Established first available free memory
CE42 Align input buffers for DMA transfer
CE43 Initialize I/O driver pointers
CE44 Write welcome message to console
CE46 Reading LIF volume label
CE47 Getting values form volume label
CE48 Reading LIF directory
CE49 Find disk address and size of DUMPARE LIF file
CE4A DUMPARAE found, start writing to disk
CE4B Memory written to DUMPARAE, proceeding to ISL
CE4C Finding ISL disk address and size
CE4D Reading ISL
CE4E Launching ISL
CE4F Writing error message
CE50 Calling IODC to write message to console
CE51 Configuring memory controllers
CE52 Completed memory controller configuration
Table 4-19. HP-UX ISL Boot Codes
Code Description
CB00 Transfer of Control (TOC) initiated by the firmware
CEC0 HP-UX boot has been loaded and initialization begun
CED0 HP-UX boot has entered main
CED2 HP-UX boot is about to configure the I/O system
CED4 HP-UX boot is about to mount the root file system
CEDA HP-UX boot is about to list the contents of a directory
CEDB HP-UX boot is about to load the kernel into memory
CEDC HP-UX boot is about to start a copy operation
CEDD HP-UX boot is about to stop (return to Remote Data Base)
CEDE HP-UX boot is about to return to ISL
CEDF HP-UX boot is about to launch the kernel
To Next Page
Loading...
