Display Codes 4-27
WARNING: The Core I/O board or system board has failed, resulting in
reduced I/O slot availability.
Use the IN IO command to verify .
WARNING: Not enough error-free contiguous memory (GoodMem). Refer to
the “ME “ command in the INFORMATION menu and the “PDT “
command in the SERVICE menu for error information.
Check the PDT and replace SIMMs as necessary
Memory page deallocation has been disabled because the Page
Deallocation Table (PDT) is full. If the Boot command is
disabled, a memory error was detected after the table was full.
Refer to the “PDT “ command in the SERVICE menu for error
information.
Check the PDT and replace SIMMs as necessary.
WARNING: Memory has been initialized, but not tested as a result of
FASTBOOT being enabled. To test memory, use the “FASTBOOT “
command in the Configuration menu and reboot the system.
Disable FASTBOOT by the "Fastboot OFF" command in the CONFIGURATION menu and
reboot the system.
WARNING: Memory configuration is not optimized for performance. Refer
to the System Installation or Memory Installation manuals for
memory configuration guidelines.
Re-sequence the memory SIMMs in accordance with the referenced guidelines (also contained in
Appendix C of this manual).
WARNING: An empty memory slot has been detected which should contain
a SIMM. BOOT COMMAND DISABLED.
Re-sequence the memory SIMMs in accordance with the guidelines contained in Appendix C of
this manual.
WARNING: Memory has been reconfigured due to a physical change or
because the Page Deallocation Table (PDT) was cleared. This is
for information only. No action is required.
Advisory message only.
WARNING: Memory has been deallocated due to a SIMM size mismatch or a SIMM
failure. Refer to the “ME “ command in the INFORMATION menu
for error information.
Verify that the SIMM pairs (0A/0B, 1A/1B, etc.) are of the same size.
WARNING: Memory is not configured for optimized performance due to
an improper distribution of memory module types across
extenders.
Re-sequence the memory SIMMs in accordance with the guidelines contained in Appendix C of
this manual.
WARNING: A Processor has failed selftest and has been deconfigured.
Refer to the “PR “ command in the INFORMATION menu for a list
of deconfigured processors.
A processor failed the Floating Point Unit selftest. Replace the processor card.
To Next Page
Loading...
