Install and Configuration 2-13
Installation:
1. The graphics device adaptor (A2999A or A3519A) card should be installed in the Core I/O card,
Optional I/O slot, when no HP-HSC Expansion I/O card is present. If the 2 or 4-slot HP-HSC
Expansion I/O card is present, then the graphics device adaptor must be installed in the Expansion
I/O card . This is to avoid address overlap problems when graphics device adaptors are installed in
both the Core I/O and Expansion I/O cards.
The HP VISUALIZE 48 3D Graphics will occupy the slot normally used by the HSC I/O card.
2. Use the graphics monitor cable that comes with the graphics monitor to connect between the graphics
card and graphics monitor.
3. Connect the graphics keyboard to the Core I/O card connector marked
KEYBOARD.
4. Connect the graphics mouse to the Core I/O connector marked MOUSE.
The Keyboard path address is 10/12/7.0 and the Mouse path address is 10/12/8.0. These address paths are
set and cannot be changed, they correspond to the connectors on the core I/O card.
Since the graphics monitor connects to a graphics device adaptor card that can be in different slots, its
address path must be configured in PDC to reflect its slot location. You must change the Console Path
Address in PDC to either 10/8.0 (for the core I/O Optional I/O slot), or one of the following path addresses
for the HP-HSC Expansion I/O card slots:
Note
The Dual Bus 4-Slot HSC Expansion I/O card does not support graphics cards.
Core I/O, Optional I/O slot 10/8.0
HP-HSC I/O Expansion card, slot 0 8/0.0
HP-HSC I/O Expansion card, slot 1 8/4.0
HP-HSC I/O Expansion card, slot 2 8/8.0
HP-HSC I/O Expansion card, slot 3 8/12.0
To Next Page
Loading...
